Filter
Top Products
INSTALLATION
1. Make a 100 mm diameter hole in a ceiling. (It is possible
to use the supplied pattern paper for a 100 mm diameter
hole.)
2. Attach the supplied gasket to the panel.
3. Connect the input cable to the speaker cable.
4. Using the four supplied speaker mounting screws (4x15),
secure the speaker to the ceiling.
Caution: Ensure that the ceiling surface is strong
(equivalent to the plywood thicker than 5 mm)
enough to hold the screws.
70 V Line COM HOT
1.5 W connection White Red
0.5 W connection White Black
100 V Line COM HOT
3 W connection White Red
1 W connection White Black
ø100 mm
(mounting hole diameter)
White (COM)
Red
(100 V Line: 3 W, 70 V Line: 1.5 W)
Black
(100 V Line: 1 W, 70 V Line: 0.5 W)
Gasket
ø139 mm
Punched grille
2 mm 94.5 mm 330 mm
4-ø4.5 mm
ø130 mm
SPECIFICATIONS
Rated Input 3 W
Rated Impedance 3.3 kΩ (100 V Line: 3 W, 70 V Line: 1.5 W)
10 kΩ (100 V Line: 1 W, 70 V Line: 0.5 W)
Output Sound Pressure Level 87 dB (1 W, 1 m)
Frequency Response 150 – 20,000 Hz
Operating Temperature Range
-
20°C to +60°C
Finish Frame: ABS resin, chrome plating
Punched grille: Stainless steel
Mounting hole diameter 100 mm
Dimensions ø 139 x 104.5 (d) mm
Weight 550 g
8 mm
Printed in Japan
333-01-039-2A
Note : The design and specifications are subject to change without notice for improvement.
• Accessories
Gasket (silicon rubber) ...................... 1
Speaker mounting screw .................. 4
Pattern paper (ø100 mm hole) .......... 1