Filter
Top Products
English
Telephone / Fax
Customer Support
www / E-mail address
Country or Region
United States
Canada
United Kingdom
Ireland
Europe, Middle East, Baltic
countries and North Africa
Australia and New Zealand
Singapore/Southeast Asia, India
Other Asia/Pacific
countries and Indian Peninsula
South Africa
www.viewsonic.com/support
service.us@viewsonic.com
www.viewsonic.com/support
service.ca@viewsonic.com
www.viewsoniceurope.com
service.eu@viewsoniceurope.com
www.viewsoniceurope.com
service.eu@viewsoniceurope.com
www.viewsoniceurope.com
service.eu@viewsoniceurope.com
www.viewsonic.com.au
service@au.viewsonic.com
www.viewsonic.com.sg
service@sg.viewsonic.com
www.viewsonic.com.tw
service@sd.viewsonic.com
www.viewsonic.com/asia
service@sd.viewsonic.com
(800) 688-6688
(909) 468-1202
(800) 688-6688
(909) 468-1202
0800 833 648
(01293) 643910
Contact your reseller
Contact your reseller
+ 61 2 9906 6277
+ 61 2 9906 6377
+ 65 6273 4018
+ 65 6273 1566
+ 886 (2) 2246-3456
+ 886 (2) 8242-3668
+ 886 (2) 2246-3456
+ 886 (2) 8242-3668
ViewSonic SP2104 7
Appendix
This equipment has been tested and found to comply with the limits for a Class B digital
device,pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to redio
communications. However, there is no guarantee that interference will not occur in a
perticular installation. If this equipment does cause harmful interference radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
FCC Warning
To assure continued FCC compliance, the user must use grounded power supply cord
and the provided shielded video interface cable with bonded ferrite cores. If a BNC
cable is going to be used, use only a shielded BNC(5) cable. Also, any unauthorized
changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this device.
Compliance Information for U.S.A.