Filter
Top Products
attach the speaker to the bracket by tightening
completely the upper conical tipped bolt with the
hexagonal tool (Allen wrench/ key). Please make
sure that you use the same conically milled point
on both, lower and upper, inlays.
ATTENTION:
For safety reasons it is recommended that all
connection bolts be tightened every six months.
B. Free-standing application:
Connecting the speakers to the aluminium stands
(please see drawing):
ATTENTION:
Usually, you want the tweeters to look in two
different directions. In this case, you have to act
as follows:
1. Please put on the enclosed gloves to avoid
fingerprints.
2. Put your pair of speakers in front of you in a
way that the tweeters are to the inside.
3. Pull out the inlay of each speaker. Since they
are attached with magnets, they simply pull off.