Filter
Top Products
5
Turntable Assembly
Installing the balance Weight
Slip mat
ASSEMBLY AND SET-UP
• If the player is operated without fixing the screws, the
platter may not rotate properly.
• Do not plug in to a power outlet until this unit is fully
assembled and adjusted.
qPlace the platter on the center spindle. The platter will adjust
itself to best fit over the spindle.
wAdjust the positioning of the platter so that the screw holes line
up perfectly.
eScrew and tighten accordingly.
rPlace the slip mat on the platter.
*** Care should be taken to avoid dropping either/both, the
platter or the cabinet.
qPlace the slip mat on the platter. Then place a record on top of
the slip mat. The slip mat is essentially used to give you better
control over the spinning of your record. That is, with the slip
mat in place you are able to stop, pull or push the record
without affecting the rotation of the platter.
Top : Record disc side (Printed side)
Bottom : Slip surface side
(
The slip mat included with this unit may
differ from illustrations in this user guide or
in other publications.
)
qFrom the backend of the tone arm (towards the rear panel)
place the balance weight onto the shaft and turn counter
clockwise. (Refer to the illustration)
DRIVER
q
e
r
w
PDX-2300MkII PDX-2300MkII Pro