Filter
Top Products
8
ADJUSTMENT
(
S
)
qCarefully release the tone arm from the tone arm clamp.
Adjustment of Horizontal Zero Balance
The balance weight and cartridge are
balanced, the tone-arm is held horizontal.
The balance weight setting is too heavy.
The balance weight setting is too light.
eReturn the tone arm to resting position.
wTurn the balance weight clockwise or anti-clockwise until
balanced horizontally.
When adjusting the horizontal balance, take care not to
touch the stylus.
In case of PDX-2300MkII Pro, adjust the Dynamic
Needle Pressure Adjustment Knob in the position of 0.
Adjustment Of Overhang
15mm
Center Spindle
ToneArm Center
Stylus Tip
Disk
15mm
Center
Spindle
As shown in the illustration, overhang indicates the distance from
the stylus tip to the center of the turntable spindle when the stylus
tip falls on the extension of a straight line from the pivot of the
tonearm to the center of the spindle. If this adjustment is not
correct, the stylus will not track the grooves properly.
qLoosen the two cartridge mounting screws.
wPosition the tonearm over the center spindle.
eSlide the cartridge until the stylus tip is at specified distance
from the center of spindle. (see illustration)
rOnce proper distance is obtained, tighten the cartridge
mounting screws.
Be careful not to touch your finger to the stylus tip during the
adjustment.