Filter
Top Products
Page 15 / 22
By turning right the Selection knob, we process to the subwoofer
boost selection, defaulted to OFF.
By turning right the Volume knob, it is enabled through the +3dB
and +6dB options.
By turning right the Selection knob, we process to the subwoofer
phase selection, defaulted to 0°.
By turning right the Volume knob, the phase is increased by
steps of 10° up to 180° (maximum).
By turning left the Volume knob, the phase is decreased by
steps of 10° down to -180° (minimum).
Last in the set-up program, we can teach the preamplifier some
new remote control codes. This functionality is only to be used
when using a new remote control.
This option is defaulted to OFF (disabled). Turn the volume
knob right to enable it. Turning left sets it back to OFF.
LEARN RC5
ERROR
To use this functionality, select ON then exit the set-up. The
screen displays LEARN RC5 ERROR. Now press any key from
the remote control. The operation is complete. The preamplifier
displays back its welcome screen.
[EXIT]
Push lightly on the Selection knob to exit at any step from the
set-up program. Parameters are now stored within the
preamplifier.
In normal mode (outside set-up) the stand-by mode can be
activated from the remote control. It will put the mono amplifier
blocks (V100A Reference) in stand-by mode (to lower the current
consum
p
tion when the e
q
ui
p
ments are not used
)
. See
Q
&R.