Filter
Top Products
8
.
www.velodyne.com
VMS User’s Manual
T
he Velodyne subwoofer is designed to operate using the full range audio signal for input when
using the built-in crossover. Many home theater processors/receivers (Dolby Digital
®
, DTS
®
,
THX™) have a “subwoofer out” jack that is internally filtered and designed to be used with a
powered subwoofer. In these installations, you may bypass the internal crossover in either the
processor or the Velodyne subwoofer. In some installations, it may be beneficial to have a
steeper ultimate crossover slope. To do this, you can use both your processor’s crossover and
the one internal to the Velodyne sub. You should stagger the frequencies, (i.e., 120 Hz sub,
80 Hz processor) for best results.
To bypass the subwoofer’s internal crossover when the unit is being fed a low pass signal from
another crossover, simply locate the switch marked INTERNAL X-OVER/SUBWOOFER DIRECT
on the rear panel of the subwoofer and set to the SUBWOOFER DIRECT position. This will
eliminate the internal crossover from the signal path.
When installing your new Velodyne subwoofer using the line level connections, you should
always use shielded phono cables. There are many high quality cables available today. It is
recommended that you keep the length of cable as short as possible to avoid any potential
noise problems.
When using speaker level connections, use a high quality speaker cable that mates well with
the connectors. Be ver
y careful to avoid any loose strands or frayed wires that may result in a
shor
t, which may damage your equipment. Cables of extremely large size are typically not
required. Extr
emely large gauge wire may not pr
operly fit in the binding posts, resulting in a
poor connection and possible short circuits.
Subwoofer Outputs
Interconnect Cables