Filter
Top Products
Figure 1. Installation Using LFE Line-Level Inputs
Note: If not using an external crossover, you should use the built-in crossover for
optimal performance. When using a single channel input (such as a surround sound
pr
ocessor’
s subwoofer out or LFE), the auto on/of
f cir
cuit sensitivity will be affected.
When one input channel is used instead of two, the unit will see lower signal levels
pr
esent at the inputs. This may cause the unit to tur
n off when listening at low volume
levels. If this occurs, simply use a “Y” adapter (available from most dealers) to allow
your processor’s single sub line to be fed into both L&R inputs. This will make the unit
turn on at lower signal levels.
5
.
www.velodyne.com
SPLi Series User’s Manual
NOTE: SPL-800i is
identical in features
and layout to the
SPL-1000i shown.