Filter
Top Products
31
.
www.velodyne.com
Digital Drive User’s Manual
Y
ou can change any value in the presets column, then use the TEST key to review the curve
with these settings active. This is shown below.
Features of each pr
eset ar
e:
EQ. There can be a completely different set of EQs for each preset. Simply select the
pr
eset you want on the “SYSTEM RESPONSE” scr
een wher
e indicated.
Volume. This setting deviates the preset’s volume from the established system volume
of the SMS
-1. So, if you found during setup that 30 was a good setup volume for the
SMS
-1, then if you incr
eased the volume for pr
eset one to 40, the 40 volume would be
invoked when preset one were selected for listening. If the system volume is changed
(using the VOL + or VOL
– keys on the r
emote), the pr
eset volume is adjusted in lock step
with the system volume.
Crossover, subsonic filter, phase and polarity settings. Normally these will not
change fr
om pr
eset to preset. However, it may be that you are using different satellites
for dif
ferent listening modes and wish to set these settings individually for a specific
preset. Note that the “setup” values cascade to the individual values for the presets, but
you can change all the individual values if desired.
Contour frequency and level. These act as an “extra” EQ that can be used to
manipulate the fr
equency contour of your SMS
-1 when this par
ticular preset is invoked.
For example, notice that preset one raises the level by 3 dB at 35Hz
– this is to
accommodate action/adventure movie content.