Filter
Top Products
7
.
www.velodyne.com
DEQ-R Series User’s Manual
(
2) SPEAKER LEVEL OUTPUT Terminals
Sends a crossed-over speaker-level signal to the front speakers. See below for a
m
ore detailed explanation of this crossover.
(3) IR INPUT
This is a connection to allow you to purchase a third-party infrared remote sensor
on an extended cable for placement closer to your other remote controlled
equipment. This keeps you from awkward control angles using the infrared
remote control.
(4) LINE OUTPUT
Connect these jacks to the LINE IN preamp input to use the DEQ-R’s internal high
pass crossover. The signal fed from these connectors is rolled off below 120 Hz.
LINE INPUT/LFE
Connect these jacks to the LINE OUT preamp output, LFE output, or subwoofer
output jacks of your receiver/processor. If using the LFE output from your receiver
or processor, plug the single cable into the “L” – LFE input or, for more signal, use
a “Y” connector (not included) and feed the signal into both “R” and “L” inputs.
(5) AUTO ON/OFF Switch
Use this switch to select between “stand-by” mode (woofer shuts off after eight
minutes) and “always on” operation.
(6) VOLUME Control
This control allows you to balance the output from the subwoofer to the main
speakers in your system. This control should be set to achieve similar volume level
fr
om between both the main speakers and subwoofer. When pressing volume up
or down, set the level while watching the LED display for reference.
Note: Volume is also contr
ollable by using the supplied r
emote. When defaults are restored,
the default is 30 out of 80.
(7) LOW-PASS CROSSOVER
Use this knob to select the frequency above which you wish to cut off the signal to
the subwoofer. When the knob is turned all the way to the left, the Subwoofer
Direct feature is invoked and the subwoofer plays all frequencies up to 120 Hz.