Vector DA-250DH CU Stereo Amplifier User Manual


 
10
Step 1. Switch off the unit's power.
Step 2. Set the BRIDGE ON/OFF switch and CH 1 mode ON/OFF switch.
Step 3. Connect the sound source equipment to the Input terminals.
Note: Refer to p. 12 for the removable terminal plug connection.
Step 4. Connect speakers to the Speaker output terminals.
4-1. Unscrew the output terminal cover.
4-2. Strip 10 mm (0.39") of insulative jacket from the end of the speaker cable,
as shown in the figure at right.
4-3. Connect speaker cables to the output terminals.
4-4. Replace the output terminal cover in place.
Be sure to replace the unit's terminal cover after connection completion.
Because high voltage is generated at the speaker output terminals,
never touch these terminals to avoid electric shock.
(DA-250DH only)
WARNING
Input terminals
Speaker output terminals
(with a terminal cover)
CH 1 mode ON/OFF switchBRIDGE ON/OFF switch
[Rear panel]
Note: The figure shows the DA-250D.
10 mm
(0.39”)
8. SETTINGS AND CONNECTIONS