Filter
Top Products
Page 20
DMS-AV HOME THEATER AMPLIFIER
Video Inputs - Hardware Connections
Video Input Connection – HDMI
The URC surround processor provides 5 HDMI A/V inputs. While HDMI
carries both audio and video, URC allows options to process audio and
video separately (please see the menu setup for further options). To connect
an HDMI video source to the URC DMS AV, connect the HDMI cable to
the HDMI output on the source. Then connect the other end of the cable
into the corresponding HDMI input on the processor. Shown below is an
HDMI output on the source going into IN 9 on the DMS-AV.
Video Input Connection - Component Video
The DMS-AV provides two sets of
component video inputs. Each
component input corresponds to a
set of stereo analog inputs, labeled
with the same input number.
Optical digital inputs and
coax
digital inputs are available to be
assigned to either of the
component video inputs. For
example, component video IN 5
could have it’s audio reassigned
to optical digital IN A. Shown is a
component video source
connected to IN 5 on the DMS-AV.
Video Input Connection - Composite Video
The DMS-AV provides four composite video inputs. Each composite input
corresponds to a set of stereo analog inputs, labeled with the same input
number. These inputs may be used to up-convert a composite video signal to
the HDMI output. Connect the composite video output on the source using an
RCA cable to the yellow colored input on the DMS-AV. Shown below is a
composite video source with an RCA
connection going into the yellow RCA
input of IN 1.
HDMI connection to HDMI source
Component connection to video source output
Composite
connection to video source