13
To... Press...
cancel a page
End
.
answer a page
inTErcoM/clEar
or
Talk/Flash
.
end an intercom call
End
. Both handsets return to standby.
Chain Dialing
If you often have to enter a series of digits or a code number during a
call, you can save that code number to a phonebook entry and use the
phonebook to send the code number.
1. Enter the code number (up to 20 digits) into the phonebook just like
a regular phonebook entry. Be sure to enter the code number into the
phonebook exactly as you would enter it during a call.
2. When you hear the prompt that tells you to enter the number, open the
phonebook and find the entry that contains your code number.
3. Press
MEnu/sElEcT
to send the code. If you change your mind, just close
the phonebook.
Voice Message Notication
If you subscribe to a voice mail service, your phone displays the voice
mail icon ( ) when you have a new message. This feature supports
Frequency-Shift Keying (FSK) and Stutter Dial Tone (SDT) notification,
which you can turn on and off through
Global Setup/Voice Mail Tone
.
After you listen to your messages, the message icon turns off. If it doesn’t,
you can reset it: With the phone in standby, open the menu and select
Global Setup
; select
VMWI Reset
, then select
Yes.
Setting Up Voice Mail Access
If you have voice mail access through your service provider, you can
program that access number into your phone and then just press one key
to dial -
MEssagE/MuTE
. You will set up an access code to your account, and
you can either enter that manually after you have accessed the voice mail
or you can program that into your phone, too.
1. Press
MEssagE/MuTE
. If no voice mail access number has been set up, the
system prompts you to do that now.
2. Enter the provider’s voice mail access number. Press
MEnu/sElEcT
to set
the number.
3. The screen displays
DONE!