Filter
Top Products
32
set-up
special
instructions
lighting tree
accessories
1
2
3
STEP 5
Loosen hand knob on the telescoping collar and raise center tube
6-10”. Retighten hand knob.
STEP 6
Put speaker cabinet on top, slowly loosen hand knob and raise cabinet
to desired height. Tighten hand knob.
NOTE: Stand load capacity is 150 lbs. (68.2 lbs.)
To lower speaker, slowly loosen hand knob. Use caution.
1. Occasionally clean the stand with a damp
cloth or non-abrasive cleaner. Do not lubricate
or use silicone spray on the center tube.
2. When loading the tripod, ONLY add the
speaker when the tripod is in a fully upright
position (all legs on the floor).
3. Do not drag the Tripod Speaker Stand while
it is loaded; this could cause breakage of the
fittings and result in damage to the stand.
4. When supporting equipment, check that
the telescoping collar is securely tightened
and the safety pin is inserted into slot on
upper telescoping tube.
5. Always release the collar with caution and
stand clear of load.
STEP 1
Loosen leg fitting hand knob.
STEP 2
Turn stand upside down and pivot legs so Ultimate Support label
faces you.
STEP 3
Turn stand upright and slide leg fitting to adjust diameter of leg
spread. Leg braces should be parallel to floor for maximum stability.
Tighten hand knob.
Zippered Tote Bags
Speaker Stand
Mounting Bracket
Speaker Stand Socket
Mounting Bracket
BMB-200K (#10766)
External bracket securely mounts any
speaker cabinet with a flat bottom on
an Ultimate Support speaker stand.
TSM-150MK (#13421)
TSM-138MK (#13425)
Internal metal bracket securely mounts
any speaker cabinet with a flat bottom
on an Ultimate Support speaker stand.
STEP 4
The built-in adapter fits both 1-1/2” or 1-3/8” internal diameter speaker
sockets. Use the lower position for 1-1/2”. For 1-3/8” sockets, depress
push buttons and raise adapter until it locks in raised position.
4
5
6
Turn a Tall TS-88B Speaker Stand into a
Lighting Tree.
For a Single-Tier Lighting Tree add:
LTB-48B (#14107)
48” Lighting Crossbar
For a Two-Tier Lighting Tree add:
LTV-24B (#14108) 24” Vertical Extension
LTB-48B (#14107) 48” Lighting Crossbar
LTB-24B (#14106) 24” Lighting Crossbar Pair
Heavy-duty, padded, zippered
Tote Bags
BAG-90 (#15691)
Holds one TS-80B/TS-80S Speaker Stand.
10.5” x 49.5” (267 mm x 1257 mm)
BAG-90D (#15693)
Holds two TS-80B/TS-80S Speaker Stands.
14.5” x 49.5” (368 mm x 1257 mm)
BAG-99 (#15692)
Holds one TS-88B Speaker Stand.
10.5” x 60.5” (267 mm x 1537 mm)
BAG-99D (#15694)
Holds two TS-88B Speaker Stands.
14.5” x 60.5” (368 mm x 1537 mm)