Filter
Top Products
Quick Start Guide
TCS series
TCS series Quickstart Guide v1.0 - Page - 5
FK-1061 FLYING SYSTEM WILL SUPPORT A COLUMN OF UP TO 5 CABINETS DEEP
FK-1061 Flying Kit
Enables suspension of one column of TCS-1061 cabinets up to 5 deep from a single flybar, and utilising an identical
flybar fitted with pull-back links to provide a pull-back for the whole cluster. One kit is required per loudspeaker array
(two kits are required to hang left and right arrays). Blanking plates are provided to fit in place of the rear flying strips
on the top cabinet.
The kit consists of:
2 x flybars
2 x pull-back links
2 x blanking plates
4 x M6 x 20mm socket head
screws
4 x M6 split washer
The single flybar provides three
pick up points to allow for either
a single lift point or double lift
points, or to provide a single pull-
back point or two pull-back
points.
Rigging an Array of up to 5 cabinets with the FK-1061 flying kit
1. Attach a flybar to the front flying strips of the first cabinet using the M6 x 20mm socket head bolts and split
washers provided. This flybar will become the lifting bar and is used to hang the array. Attach this bar to the
external rigging or motor.
2. Remove both of the rear flyplates from the first cabinet and replace them with the two blanking plates supplied
with the flying kit.
3. Lift the flybar array together with the first cabinet, and connect the second and additional cabinets underneath
the first cabinet using the four M6 x 45 high tensile screws and M6 split washers provided, and set the inter-
cabinet angles as desired. Tighten all fixings and raise the array into position.
4. Fit a blanking plate to each end of the remaining flybar using the M6 x 20mm socket head screws and split
washers provided.
5. When attaching to static rigging positions the suggested method is to pre-build the entire array including the
lifting bar and pull-back bar, and then lift the array into position using appropriate lifting equipment.
FLYBAR
PULL-BACK BAR
PULL-BACK LINK
BL
A
NKING PL
A
TE