Filter
Top Products
user manual
Impact 50
Impact 50 manual
page 7
♦ Attaching to a scaffold bar or to a
microphone stand by means of the SM-50
SM-50SM-50
SM-50
single point mount bracket. For microphone
stand use simply remove the microphone
clip from the mic stand and locate the
threaded end through the hole in the top of
the SM-50 bracket. Tighten with the wing nut
provided. For use with a scaffold bar, place
the bracket over the bar and tighten with the
supplied M6 screw until secure.
♦ Fixing to a wall or ceiling using the SB-50
SB-50SB-50
SB-50 swivel
bracket. When used vertically as shown attached
to a wall, the enclosure is free to rotate in the
horizontal plane over more than 180°. It can also
be turned through 90° and mounted horizontally
on to a wall in which case the enclosure can be
tilted downwards to give the desired coverage.
The SB-50 can also be fixed to a ceiling, again
allowing for a wide range of adjustment of the
enclosure.
The CB-50
CB-50CB-50
CB-50 cluster bracket enables
four Impact 50 enclosures to be
ceiling mounted in a 360° cluster
with fixed downward angle. It is
designed for use with 15mm
(1/2”) conduit (not supplied),
which carries the loudspeaker
cable to the enclosures.