Tripp Lite B125-150 Stereo Receiver User Manual


 
2
3
1. Introduction
The B125-150 HDMI Over Cat5/6 Extender can extend an HDTV signal beyond the standard
15-ft. limitation, as shown in the installation diagram. For maximum range use solid wire Cat6
(24AWG) cable. When used, ranges will be: 480p resolution—up to 230 ft. (70 m); 720p
resolution—up to 196 ft. (60 m); 1080p resolution—up to 115 ft. (35 m). Use Tripp Lite P568-
series HDMI cables to connect the Extender to the HDMI source and monitor.
Product Features
• Fully automatic equalization up to 40dB; no system control required
• Eliminates equipment noise in the viewing environment
• Compatible with 480p, 720p, 1080i and 1080p resolutions
• HDMI and HDCP compliant
Package Contents
• HDMI Extender Source Unit • HDMI Extender Remote Unit
• Power Adapter • Owner’s Manual
2. Installation
1
Connect the HDMI source to the B125-150 Source Unit using a Tripp Lite P568-series
HDMI cable.*
2
Connect the HDMI display to the B125-150 Display Unit using a Tripp Lite P568-series
HDMI cable.*
3
Connect a Tripp Lite N001- N002 or N201-series Cat5e/6 cable* from Port A of the
B125-150 Source Unit to Port A of the B125-150 Display Unit.
4
Connect a Tripp Lite N001-, N002 or N201-series Cat5e/6 cable* from Port B of the
B125-150 Source Unit to Port B of the B125-150 Display Unit.
Note: If the Cat5/6 cables are cross-connected (A to B and B to A) the Extender will not
function. To avoid this problem, either tag the cables or use differently colored cables, e.g.
black and red.
5
Connect the included Power Adapter to the B125-150 Display Unit, then plug it into an
AC power outlet. To prevent damage and assure peak performance, it is recommended
that the Power Adapter be plugged into a Tripp Lite Surge Suppressor.
Note: Depending on signal and cable quality, the Power Adapter may not be required.
However, Tripp Lite recommends using it at all times.
* HDMI and Cat5e/6 cables sold separately.
3. Troubleshooting
If the image is not displaying properly:
1
Check to ensure that Connectors A and B on the source side are connected to
Connectors A and B on the display side. If the Cat5/6 cables are cross-connected (A to
B and B to A), the Extender will not function.
2
Check to ensure that you are not using Cat5e/6 cross-over cabling. If this type of
cabling is used, the Extender will not function.
3
Verify that the HDMI source and display are functioning properly by connecting them
using a Tripp Lite P568-series cable no longer than 15 ft. If the source and display
are functioning properly, test the Cat5/6 cabling by connecting it between two Cat5/6
devices. If the Cat5/6 cabling is functioning properly, contact Tripp Lite Technical
support at (773) 869-1234 for further assistance.
4. Warranty and Warranty Registration
1-Year Limited Warranty
TRIPP LITE warrants its products to be free from defects in materials and workmanship for
a period of one (1) year from the date of initial purchase. TRIPP LITE’s obligation under this
warranty is limited to repairing or replacing (at its sole option) any such defective products. To
obtain service under this warranty, you must obtain a Returned Material Authorization (RMA)
number from TRIPP LITE or an authorized TRIPP LITE service center. Products must be returned
to TRIPP LITE or an authorized TRIPP LITE service center with transportation charges prepaid
and must be accompanied by a brief description of the problem encountered and proof of date
and place of purchase. This warranty does not apply to equipment which has been damaged by
accident, negligence or misapplication or has been altered or modifi ed in any way.
EXCEPT AS PROVIDED HEREIN, TRIPP LITE MAKES NO WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE. Some states do not permit limitation or exclusion of implied
warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to the purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT,
INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE
USE OF THIS PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
Specifi cally, TRIPP LITE is not liable for any costs, such as lost profi ts or revenue, loss of
equipment, loss of use of equipment, loss of software, loss of data, costs of substitutes, claims
by third parties, or otherwise.
Warranty Registration
Visit www.tripplite.com/warranty today to register the warranty for your new Tripp Lite product.
You’ll be automatically entered into a drawing for a chance to win a FREE Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.
Tripp Lite follows a policy of continuous improvement. Product specifi cations are subject to
change without notice.
Made in China.
B125-150
Display
B125-150
Source
Cat5/6 CablesP568-Series
HDMI Cable
P568-Series
HDMI Cable
Up to 15 ft.
Distances as noted above
TV Monitor
HDMI
Source
200804229 93-2786 HDMI Over Cat5 OM.indd 2-3200804229 93-2786 HDMI Over Cat5 OM.indd 2-3 6/9/2008 10:30:36 AM6/9/2008 10:30:36 AM