Filter
Top Products
14
TMB Programmable Multiband Amplier
TMB 10A • TMB 10B • TMB 10S
GB
C
C
C
A
A
A
R
R
R
D
D
D
M
M
M
e
e
e
n
n
n
u
u
u
TMB units have an SD/MMC interface to save or read configurations and for updating the product.
This menu includes 4 sub-menus:
• APL updating of the firmware
When the card contains the update file (tm_tmb10.tlp), and the enter key is pressed; the update
occurs automatically and the display shows "boot" during the whole operation.
• EHP data memorization
Select the sub-menu and choose a filename. The display flashes when the file already exists. By
pressing the enter key, it is “overwritten".
• InP read the configuration files
Select the sub-menu and display the name of the file to read. When the key is pressed, reading
starts; the display shows "Good" when the procedure is complete.
• PIN activation and configuration of the PIN code
When this function is active, the PIN code is requested to access the menus (display your PIN code
using the keypad and confirm by pressing enter). If no key is pressed for 30 seconds, the unit
switches to standby mode and the PIN code must be entered again to access the menus.
Important.
• When no SD card is inserted in the unit, the display indicates Err when one of the menus
APL, EHP or InP is used.
• The SD/MMC card must be formatted in FAT16. The files should be placed in the root
directory.
• The configuration files are names specifically according to the model number (S00x for
TMB10S, B00x for TMB10B, A00x for TMB10A).
• The default PIN code is 2312.