Filter
Top Products
English
4
Antenna Base Mounting Methods & Configuration
PLEASE READ THE FOLLOWING INSTALLATION
STEPS BEFORE DRILLING HOLES IN THE WALL.
After removing the bottom cover from its seating, remove the
metal weight plate from the ceiling clips to expose the screw holes.
Press Tab
Lift Cover
Remove weight plate
Select location
Place
base template
Mark screw
position
WARNING: Please make sure that the AP / Client device
can reach your selected antenna position (Antenna Cable is 1
meter / 3 feet)
After you have marked the wall for the appropriate drilling sites, re-
assemble the antenna stand without the metal weight. The clips
should not protrude.
In order to decrease the weight and increase the
magnetic power, it is highly recommended that the metal
plate be removed before installing antenna onto ceiling,
partition, or any metal surface.