Filter
Top Products
11
PREPARATION
Setting up the Remote Control
1
Open the battery compartment lid on the
rear panel.
2
Install 2 batteries (“AA” size) following
the polarity diagrams.
3
Close the battery compartment lid.
4
Point the remote control at the VCR and press the buttons within the operating range.
Distance: within about 7 m from the front of the remote sensor
Angles: within about 30˚ in every direction
Notes on batteries
• The life of the batteries is about 1 year
depending on the conditions of use.
• If the remote control does not operate correctly,
replace all batteries with new ones.
• If the remote control is not to be used for a
long period of time, remove the batteries to
avoid possible damage from battery corrosion.
Caring for the remote control
• Do not expose the remote sensor of the VCR
to a strong light source such as direct sunlight
or illumination (especially high-frequency
lighting) when using the remote control.
• Be careful not to spill water on the remote
control or to place it on anything wet, and avoid
sharp impacts.
+
+
How to Use the Remote Control
This section explains how to get ready for remote control operation.
PREPARATION
W-528 522 422 eng (11-19) 2/28/02, 2:28 PM11