Filter
Top Products
5
TANNOY SR601
SR601 Rock Speaker
5.0 CONNECTIONS
Caution: Do not attempt to connect the speakers to any source or amplifier that is turned on. Be sure the source or amplifier is off prior to connecting
the speakers.
Parallel or series wiring is commonly acceptable for the SR601 rock speaker to gain correct amplifier loading. Avoid series wiring your SR601
speakers with any other speaker type or brand.
Polarity - Speaker wires are marked for polarity consistency so that you can determine the positive and negative identity of the individual wires
within the molded pair insulation. Polarity shown by either a color stripe on the insulation, by ridges molded into one side of the insulation, the
color of the insulation case around the wire or by the color type or colors of the wires/wire itself (copper or silver).
Important: In order to maintain correct polarity, always connect speaker wire using the positive (+) terminal on the amplifier to the positive (+)
wire and the negative (-) terminal on the amplifier to the negative (-) wire.
For a typical audio installation, all speakers in a system will be connected with the same respective polarity.
For best results, crimp or solder the wire together using heat shrink to seal each individual conductor. After the individual conductors
are sealed, seal over the pair with another layer of heat shrink.
Connection Tip: You may also use twist nuts specially designed for outdoor applications. The twist nuts have a silicone cone inside the nut head
and coat the connection once attached. These special nuts are not included but are widely available.
5.2 Polarity
6.0 TECHNICAL DRAWINGS
275mm ±5
290mm ±3
11.4" ±3
10.8" ±5
280mm ±3
11" ±3