Filter
Top Products
5.1
SATELLITES
PERFORMANCE
Recommended amplifier power
15 - 100 watts
Maximum Sensitivity (2.83Volts @ 1m) 85dB
Nominal impedance: 6 ohm
Frequency response (-6dB) 140Hz-78kHz
Drivers: HF: 15mm ( inch) titanium dome,
Neodymium magnet system.
LF: 75mm (3 inch) paper cone
Crossover frequency 4.5kHz (mid to high)
140Hz (to subwoofer)
Magnetic shielding: Yes
Weight: 750gms (1.65lbs)
Dimensions H x W x D: 140 x 97 x 95mm
5 x 3 x 4 inch
Finish Silver or black
Supplied accessories Wall mounting brackets
25 metres (82 ft 6”) speaker cable
Optional accessories Satellite floor stands available in
matching silver & black
SUBWOOFER
PERFORMANCE
Power output 100W RMS
Frequency response (-6dB) 45Hz - 140Hz
Driver 200mm (8 inch) paper cone
Inputs Twin line or speaker level
Power requirements 115 or 230V AC / 50 - 60 Hz,
switching facility on amplifier
panel, 160VA max.
Fuse ratings
AC100-120V / 60Hz - Fuse: T1.6A L /125V.
AC 220-240V / 50Hz - Fuse: T800mA L /250V
Additional features ON / OFF/ AUTO power function
Weight 10kg (22lbs)
Dimensions H x W x D 400 x 230 x 405mm
15.75 x 9.0 x 16.0 inch
Finish Silver or black
6481 0381
Tannoy Limited, Home Audio Division, Coatbridge, Scotland, ML5 4TF.
Tel: +44 (0) 1236 420199 Fax: +44 (0) 1236 428230
e-mail: sales@tannoy.com www.tannoy.com
FOR YOUR OWN PROTECTION
• Store the complete packaging in case it is needed for re-use.
• Never expose the unit to moisture, water and extremes of temperature or humidity. Specifically, the unit shall
not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed
on the unit. Allow 150mm behind the unit to allow for sufficient ventilation. Articles such as newspapers,
tablecloths, curtains etc must not impede the ventilation. Do not operate with the rear panel facing a radiator
or heater. No naked flame sources, such as lighted candles, should be placed on the apparatus.
• Never remove the rear panel of the unit, as there is a risk of electric shock.
• There are no user serviceable parts inside the unit. Always refer servicing to your Tannoy dealer or authorised
service agent.
• Avoid violent shocks to the unit during packing or transportation.
• Do not plug the unit into the mains until all other connections have been made and checked.
• Due to the powerful magnet within FX 5.1 subwoofer, do not place within 1m of a television or
computer monitor.
• When set to the 'standby' and 'off' functions, a small amount of current continues to flow to the apparatus
when not in use. If not used for a long period of time, it is recommended that the apparatus is completely
disconnected at the AC mains socket.
• Terminals marked with the flash symbol are hazardous live and the external wiring connected to these
terminals requires installation by an instructed person or the use of a ready-made lead or cord.
• This apparatus is designed for use in moderate climates.
WARRANTY
Please complete and return the enclosed warranty registration document - this does not limit your legal rights.
This equipment has been produced and tested with care and precision. It is built to give first class service and
carries a 1-year warranty. If the equipment proves to be defective within this period for any reason other than
accident, misuse, unauthorised modification or fair wear and tear, Tannoy will repair any such defect or, at
our option, replace it without charge for parts, labour or return carriage. This warranty is given in addition to
the customer's statutory rights.
If you suspect a problem with your loudspeakers, please contact your local Tannoy dealer who will be
able to advise on appropriate action.
Tannoy adopts a policy of continuous improvement and product specification is subject to change.
Due to our policy of continuous improvement, this is a specification update
sheet that should be read along with the manual as it provides the latest correct
information. All specifications may be subject to further change without notice.
IMPORTANT
A mains cable is supplied - where the moulded plug is fitted with a mains fuse, always replace with the
same type and rating. If the fitted plug is unsuitable for your type of outlet sockets, it should be cut off
and disposed of safely. The wires in the mains cable are coloured in accordance with the following code:
GREEN AND YELLOW EARTH
BLUE NEUTRAL
BROWN LIVE
As the colours of the wires in the mains cable may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
• The wire that is coloured GREEN and YELLOW must be connected to the terminal in the plug that
is marked either by the letter E, the earth safety symbol, or coloured GREEN or GREEN and YELLOW.
• The wire which is coloured BLUE must be connected to the terminal in the plug which is marked
by the letter N or coloured BLACK.
• The wire which is coloured BROWN must be connected to the terminal in the plug which is marked
by the letter L or coloured RED.
• Ensure that the terminals are tightened securely, and no loose strands of wire are present. Ensure
cord grip is clamped over outer sheath of cable, rather than over the wires.
FUSE PROTECTION
An additional mains fuse is provided in the IEC power inlet on the amplifier panel, removable with
a screwdriver. A fuse of the same type and rating must always replace this.
The correct type is 5mm x 20mm Time Delay (Type T):
• T1.6AL / 125V for AC 220-240V / 50Hz operation,
• T800mAL/ 250V for AC100-120V / 60Hz operation.
/
1
2
/
4
5
/
5
16
/
5
8