Filter
Top Products
___________________________________________________________________________
page 18
6.9 Return to factory setting
Each setting in the configuration menu will be stored even if the power is removed.
However, if your entire set-up doesn’t work well, it may be desirable to reload the
original factory settings.
If this option is selected by the ”⇒” key, the user will be asked SURE ? in the
display. If accepted, the user must push the “ENTER” key. Otherwise cancel by
pushing “⇐” or “>VOL”.
Please notice that delay and volume trim settings will be returned to their original
settings with this command.
6.10 OSD
The information on the front panel display can also be displayed on the TV-set or
Projector (On Screen Display), by the built-in video encoder.
When entering the config menu, a full screen OSD is enabled, which overrides other
video sources.
In normal mode the OSD is mixed with the selected video signal.
The following settings are possible:
- OSD is disabled
- OSD is enabled only by commands from the remote control (factory setting)
- OSD is enabled both by command from the remote control and front panel keys
When no OSD is displayed, the OSD circuit is automatically switched out of the
video signal path to obtain full bandwidth of 70 MHz for maximum video quality.
6.11 SPDIF OUT
In this menu you can select what channels should be send to the optical digital
output.
The sample rate will change with different sources, e.g. analog input and DTS 96kHz
will output 96kHz, while normal DVD is 48kHz.
The receiver should be able to handle the different sample rates.
6.12 ProLogic II
In this menu it is possible to select the default setting of ProLogic II for each input.
You can choose between movie and music mode, depending on what type of
material is commonly used.