Filter
Top Products
Getting Started
Connecting to Audio Components
4
AUDIO INPUT
DVD SAT
TV
VCR
CD
TAPE
DIGITAL AUDIO
COAXIAL OPTICAL
L
R
IN
TV
VCR
CD Player
SAT
to LINE OUT (Tape Deck)
to AUDIO OUT (CD)
to AUDIO OUT (SAT)
to AUDIO OUT
(DVD)
to AUDIO OUT (TV)
to AUDIO OUT (VCR)
Tape Deck
DIGITAL INPUT
Connect components capable of
outputing Dolby Digital (e.g. DVD or
SAT) or standard PCM (CD) format
digital signals. Read section on
"Input Signal Setting" under
"Advanced Sound Control" carefully
to adjust the matching input
settings.
If your CD player is equipped with digital optical
jacks, use of optical cable is preferred. What you
need is just one more optical digital connecting
cable (not supplied). Plug it in the digital input jack
of the receiver and select OPTICAL on the receiver
setting (see details under "Input Signal Setting").
You can enjoy better sound quality brought to you by
the optical cable. When optical cable is used, analog
cables are still needed for recording to tape output.
DVD
DIGITAL CONNECTION
If you have a SAT receiver DVD player or CD player with a digital output, you can make use of an optical digital cable (not
supplied) or coaxial digital cable (not supplied) to carry the audio portion of the signal and enjoy Dolby Digital sound quality.
One optical or coaxial cable is needed for each SAT receiver, DVD player or CD player. When optical or coaxial cable is used,
the analog audio cables are still needed if recording through a tape or VCR is desired. This receiver provides one optical and
one coaxial digital input for the connection of your components. Please connect your components (e.g. DVD, SAT or CD) to the
appropriate digital inputs and press DIGITAL INPUT to select the corresponding digital input source.
Note: Optical and coax cables carry only the audio portion of the signal. A video connection must also be established for a SAT
receiver and DVD player.
DPL590 EN 12/16/04 3:58 PM Page 8