Filter
Top Products
Unpacking the system
You should have the following:
• one main unit (with 2 main speakers);
• one remote control;
• one user’s guide;
• one Thomson Warranty Card
Back View
1. FM Pigtail Antenna
2. Main Speaker Jacks
Using the Antenna
Before you use your audio system, you’ll want to
make sure the FM antenna is positioned properly.
The FM antenna is the coiled wire connected to
the back of the unit. Uncoil it, making sure it is
fully extended (you may even want to tape it to
the wall behind the unit, if possible. The higher,
the better.)
For better AM reception, move or rotate the unit.
Connecting the Speakers
Match the blue wire (on the left speaker) to blue
terminal for the left speaker (L) on the back of
the unit and the black wire (on the left speaker )
to the black terminal for left speaker (L). Follow
the same procedure to connect the right (R)
speaker.
Installation
To ensure sufficient ventilation, keep the spacings
shown below free from other surfaces:
2
EN
Getting Started
ON•ECO
10 cm
10 cm
Front View
10 cm
10 cm
5 cm
Side View
Release tab to lock wire in
the terminal.
NOTE: Make sure the insulation
is completely removed from the
ends of the
speaker wires at all connection
points.
Speaker
Wire Connection
Push Speaker terminal tab
down to insert wire.
1
2
A_CS90 EN 4/28/04 9:55 AM Page 7