Filter
Top Products
Selecting Tuner Band
1. Press SOURCE on the main unit or TUNER on
the remote control to enter Tuner mode.
2. Press BAND / AUTO PROG / CD INFO to select
between MW, LW or FM Radio band.
Tuning to a Station
Press SKIP BACKWARD or SKIP FORWARD
to select frequencies.
Using Presets
The tuner can be in either TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
• Press TUNE/PRESET to toggle TUNE and
PRESET mode.
• Press PRESET - or PRESET + on the
main system or FOLDER•PRESET or on
the remote control to access the previous or
next preset station. The display first shows the
preset program number and after a few
seconds, the frequency will be displayed.
(FMPR:01 is FM preset 1)
Auto Preset Programming
(FM only)
Press and hold the BAND / AUTO PROG / CD
INFO button for 2 seconds to scan stations in FM
band. The stations will then be stored as preset
channels. A maximum of 32 stations can be
stored. Beware of your preset channels being
erased accidentally because the scanning and
storing process is automatic upon pressing the
button. You can stop the automatic scan by
pressing any button, but the erased stations
cannot be recovered.
Manually Setting Presets
1. Press the TUNE/PRESET button to enter TUNE
mode.
2. Press SKIP BACKWARD or SKIP
FORWARD to access the desired
frequency.
3. Press the PROG/SET button once.
4. The most recently accessed program location
will be displayed.
5. If a different program location is preferred,
press PRESET - v or + to move to the
desired preset number (1-32).
6. Press PROG/SET to store the selected
frequency at that preset.
Suppressing Stereo Signal
Press FM ST to toggle between FM mono and
stereo mode. (Remote Only) “ST” is displayed in
stereo mode.
13
EN
Radio
Tips:
Your audio system has 32 preset stations.
CS520 EN 2/23/04 3:56 PM Page 18