Filter
Top Products
475
406
16"
356
4"
3-7/8"
14"
18-11/16"
TOP/BOTTOM VIEW
1/2"
REPLACING THE COAXIAL TWEETER MODULE
In the unlikely event that your PowerPlane loudspeaker requires service, the entire
coaxial driver can be removed from the front of the cabinet, or the tweeter module
can be replaced separately without removing the woofer.
To replace just the tweeter module, bend the end of small paper clip and hook it under
the module’s protective screen. While applying pressure against the screen with two
fingers, slowly pull the module out. When installing the new tweeter, position it so that
both module pins are placed in the two socket holes of the magnet system. Make sure
that the pin marked with a red dot is inserted into the red marked hole. After the new
module is inserted, push hard on the screen with some lateral force in all directions to
insure that the tweeter is firmly seated and sealed.
POWERPLANE CABINET DIMENSIONS
475
406
Mounting
holes
Grille covers
shaded area
16"
18-11/16"
5-7/8"
FRONT VIEW
Input
SIDE VIEW
11-1/2"
9-1/16"
9-1/2"
NOTE:INPUT CAN
BE INSTALLED IN
THE DOWN POSITION
Depth required behind wall surface: 3
7
⁄8"
Required wall opening: 9
1
⁄2" x 14" min.
10
1
⁄2" x 15" max.
in millimeters and inches
11- 1/4"
13
230
241
205