Filter
Top Products
Electro-Voice
®
SbA760 User Manual 2
1. Quick Start
Caution: Before switching on the power of the SbA760 always set the LEVEL control to its
counterclockwise stop. A playing sound source could otherwise lead to extreme
output levels.
This Quick Start Manual outlines the set up and operation of a SbA760 used as add-on subwoofer together
with a Powermixer (see configuration examples). The operation procedures are equivalent for other
mixers.
1. Set up your Powermixer system as usual and connect a signal source to the power mixer (e.g. CD
Player or microphone).
2. Place your SbA760 somewhere between your full-range cabinets.
3. Set the SbA760’s LEVEL control to its counterclockwise stop and connect the unit to a wall outlet using
the supplied PowerCon mains cord.
4. Use a stereo phone plug cable to connect the Powermixer’s MONO OUT to the SbA760’s L/MONO
INPUT.
5. Move the Mixer MONO OUT fader all the way down.
6. Be sure to switch on the Mixer first and then the SbA760.
Switching on the SbA760 last is recommended. Otherwise, unwanted power-on noise might occur.
When switching off your equipment, please proceed in the opposite order, i.e. switch off the
SbA760 first.
7. Set the SbA760’s LEVEL control to its center position (0dB) and start the playback of the desired signal
audio source.
8. After adjusting the desired acoustic output level of the full-range cabinets using the Powermixer’s master
fader, establish volume setting for the subwoofer using the MONO OUT fader.