Filter
Top Products
6 TASCAM CD-RW900
Rack-mounting the unit
If you are mounting the unit in a rack, leave 1U of space
above it and 4 inch (10cm) or more of space at the rear.
Use the rack-mounting kit to mount the unit in a stan-
dard 19-inch equipment rack, as shown in this section.
Remove the feet of the unit before mounting.
Thank you for your purchase of the TASCAM CD-
RW900 CD rewritable recorder.
Before connecting and using the unit, please take time
to read this manual thoroughly to ensure you under-
stand how to properly set up and connect the CD-
RW900, as well as the operation of its many useful and
convenient functions. After you have nished reading
this manual, please keep it in a safe place for future ref-
erence.
NOTE
This product is designed to help you record and repro-
duce sound works to which you own the copyright, or
where you have obtained permission from the copyright
holder or the rightful licensor. Unless you own the copy-
right, or have obtained the appropriate permission from
the copyright holder or the rightful licensor, your unau-
thorized recording, reproduction or distribution thereof
may result in severe criminal penalties under copyright
laws and international copyright treaties. If you are un-
certain about your rights, contact your legal advisor.
Under no circumstances will TEAC Corporation be re-
sponsible for the consequences of any illegal copying
performed using the CD-RW900.
1 − Introduction
Supplied accessories
In addition to this manual, the CD-RW900 has been
packed with the following:
≠
RC-RW900 remote control unit................................. 1
≠
AC power cable........................................................ 1
≠
AAA batteries for the remote control unit................... 2
≠
A rack-mounting screw kit (screws and washers)...... 1
Contact your TASCAM supplier if any of these items are
missing.
About this manual
In this manual, we use the following conventions:
≠
The names of keys and controls are given in the
following typeface: ERASE.
≠
When the alphanumeric portion of the display shows
a message, this is shown in the following typeface:
Welcome
.
≠
If a preset indicator in the display (i.e. one which
cannot change, but is either on or off) is shown, this is
shown as follows:
RANDOM
.
≠
Selectable value (i.e. values of dB) or ON and OFF
selection (i.e. SRC>XXX) is shown in the following
typface: XXX.