Filter
Top Products
Installation Sheet
TANDBERG Edge
Wall Mounting
Recommended
mounting
DO NOT MOUNT IT HERE!
Alternative
mounting
Alternative
mounting
Equipment needed:
Caution!
Remove the monitor. Make sure there
is space for all
cables when the
monitor is put back
in place. Also make
sure that the cable
connections will be
well hidden behind
the monitor.
Recommended
Alt. 1
Alt. 2
Unscrew the base using the
enclosed screwdriver.
Put the Edge
codec on its back.
Bracket with screw
(included).
Screwdriver to
remove the base and
mount the bracket
(included).
Suitable screws (at
least 4×15) to mount
bracket on wall (not
included). Each screw
must be able to sustain
at least 10 kg when
bracket is mounted.
Screwdriver to mount
bracket on wall (not
included).
Decide where to mount the Edge codec.
1 2 3
4
5 6
7 8
Mount the Edge codec (with all the cables connected) onto the bracket using the screw of the wall bracket. Mount the monitor and camera (see instructions overleaf) back in place.
Hose (sleeve) to
accommodate the
cables between
the codec and
the monitor and
camera (included).
Use screws in
all four holes for
mounting. Do not
rely on the center
hole alone.
Connect cables as shown overleaf.
D13922.06 MARCH 2008
Mount the bracket on the wall.
CAUTION! Never use other screws than the 20 mm screw already attached to the wall
bracket. Do not remove this screw. Using other screws may damage the codec’s interior
and will void the warranty.
D1392205_Edge_Installation_Sheet_Feb08.indd 2 10.03.2008 09:56:30