Filter
Top Products
Also, is your subwoofer turned ―ON‖? We don’t mean ―is your sub-
woofer amplifier on?‖ but rather, is your AVR sending a bass sig-
nal to your sub amp? This can only happen if you say ―Yes‖ (or
―ON‖) in the ―Subwoofer‖ selection during the setup of your AVR’s
setup menu.
Is your receiver connected to the sub amp? Use a well-shielded
―RCA‖ or XLR cable (sometimes called a ―patch cord‖) to connect the sub-
woofer output of your AVR to either input jack of your subwoofer’s dedicated
amp. Again, you’ll need to ―split‖ the bass signal with a ―Y Cable‖ if you
have a pair of subs. But you only need feed one of the two inputs (it doesn’t
matter either Right or Left) of any SVS Powered Box sub.
Is your Radio Shack ® sound pressure level (SPL)
meter ready? This tool is absolutely essential to proper
home audio setup. It’s akin to a tire pressure gauge for
your car. Set the meter to ―Slow‖ and ―C-weighting‖ (and
turn the dial to 70dB. If using Avia for calibration tones, set
your meter to 80dB instead.
Getting ready to start now: Make sure your receiver or proc-
essor’s master volume is set to ―00 dB‖ or some other easy to
remember “reference level”. Then, ensure your sub’s volume/
gain control is set no more than 1/4 to 1/3rd up, for now, leaving plenty of adjust-
ment ―up‖.
It’s also critical to check the subwoofer output level control of your AVR before
you begin the test tones. Set the AVR’s subwoofer output to about 1/3rd up too.
Turn off any sound-field processing schemes, ―Mid-night Mode‖, ―DRC‖ (dynamic
range control), ―Movie Mode‖ etc. If it is an option in your system, route your
LFE to the ―subwoofer only‖, not ―mains + sub‖.
Now play your AVR’s internal test noise “tones” so you have something to
measure with your SPL meter. When the tones start alternating from speaker
to speaker (watch your sound meter now), set each speaker’s volume to about
75 dB by using the receiver’s dedicated channel level controls (leaving your
AVR’s master volume the same).
We recommend you turn down the AVR’s subwoofer channel output level before
you significantly lower your subwoofer’s gain control. This helps keep distortion
sent to your SVS to a minimum. Note: You should not set the AVR’s subwoofer
level control much lower than the first 1/4th of the receiver’s control range.
Some downward adjustment may be needed to fine tune levels later. If your
subwoofer’s SPL meter reading is still too high, then turn down the sub’s amp
volume a little with each run of the test noise signal, as it cycles from speaker to
speaker and the subwoofer.
SV Sound
Chapter 6-3