Filter
Top Products
User's Manual
10
CHAPTER 1
Front Panel Features
1. Power
This button turns the TGP-5 on
(fully powered up) or into Standby
mode (asleep, but can be turned
on remotely).
If you press ZONE TWO fi rst, it
can turn on Zone 2 (even if the
Main Zone is off).
The red Standby LED is on when
the TGP-5 is in Standby mode.
When the TGP-5 is turned on, the
LED will go out.
To fully turn off power to the TGP-
5, for example if you are going
on vacation to Boise for a week
or two, then use the rear panel
power switch.
2. Display
This soothing display shows
which input is se lect ed, the tuner
frequency, volume level, and other
useful features.
3. Manual Input Selector
Use this control to select the
source you want to listen to.
Note: After you have selected an
input, you should check that the
TGP-5 is set to the desired sur-
round mode (or the stereo mode).
Using the On Screen Display
(OSD) INPUTS menu, each input
can be adjusted in level so that all
the inputs have similar volumes.
Each input can also be set to
enter a desired surround mode
whenever that input is selected.
4. Mode Buttons
MODE UP/DOWN
These buttons allow you to step
up or down through the various
sound playback modes.
SONIC HOLOGRAPHY
Engage this to add a three
di men sion al effect, es pe cial ly to
stereo listening.
ZONE SELECTION
Use this to select either the
main zone, or zone 2 to be
adjusted.
Note: If Zone 2 has not been
enabled (see page 36) this but-
ton has no effect.
Any changes you make after
pressing this, will affect the
selected zone. For example,
press this and POWER to turn
on Zone 2, then adjust the Vol-
ume and select an input. Press
ZONE 2 again to revert back to
Main Zone operation. It will also
revert back after a short period
of no activity.
PANEL DIM
The front panel lights have four
levels: bright, me di um, low and
off (low intensity display with
LEDs off).
MUTE
This turns off the sound. Press
it again, or adjust the volume
control to return to the pre vi ous
volume level.
12 345
67 98