Filter
Top Products
User's Manual
17
The loudspeakers have two sets of
binding posts that can be used for
biwiring or biamping. These posts
are joined with bridge clips for normal
operation.
Make sure the bridge clips are
removed from the loudspeakers
when you want to biamp or biwire
them. If not, this may cause damage to
your amplier.
In a biamp system, each loudspeaker
can be driven by two separate amplier
channels; one to drive the woofers and
one to drive the ribbon.
Biamping with a Sunre
Theater Grand Amplier
The front channels of Sunre's Theater
Grand Ampliers each have two pairs
of outputs. In a biamp system, use the
current source to drive the ribbon and
a separate channel's voltage source
to drive the woofers.
This example shows the connections
for biamping a right front speaker.
Biamping
• Connect the amplier’s right back
output to the right loudspeaker’s
woofer input terminals. Connect the
amplier’s right front current source
output to the ribbon input terminals.
• Both amplier channels are fed with
the same (right, front) line-level
signal from your preamp.
Conventional Biamping
If you are not using a Sunre Theater
Grand Series amplier (or you are
using the current source outputs for
something else), then connect sepa-
rate amplier channels to the woofer
terminals and ribbon terminals. The
ampliers should be of identical power
output and performance. Both amplier
channels are fed with the same line-
level signal from your preamp.
Amplier outputs
Sunre TGA Series Amplier outputs
MINIMUM SPEAKER LOAD IMPED ANCE 4 OHMS
MINIMUM SPEAKER LOAD IMPED ANCE 4 OHMS
MINIMUM SPEAKER LOAD IMPED ANCE 4 OHMS