User's Manual
7
7. Clamp Screws
These screws are used to clamp the
loudspeaker in place, once it has been
pressed into the sheetrock opening of
your wall.
8. Ribbon
The CRW-2C and CRW-2 use the
same ribbon driver.
9. Lens (CRW-2C only)
The CRW-2C uses an acoustic lens
over the ribbon to optimize the perfor-
mance as a center loudspeaker.
10. Grille
The grille is attached to the main body
with magnets. To remove the grille,
gently pry it away from the corners.
11. Cutout Guide
This allows you to easily mark the
required cutout onto your wall.
12. Paint Shield
This covers the drivers and frame when
painting the end caps to match the
walls.
CRW-2C
CRW-2
5
11
12
6 9
7 10
4
7
4
6
5
8
3
8