Filter
Top Products
User's Manual
6
1. Binding Posts
Each loudspeaker has one pair of gold-
plated spring-loaded binding posts.
Always use high quality connections
and speaker wires, and make sure
there are no loose ttings or stray wire
strands. The spring connections accept
bare wire or pins.
Connect the positive speaker-level
output of your power amplier or
receiver to a positive (red) input of the
loudspeaker. Connect the negative
speaker-level output of your power am-
plier or receiver to a negative (black)
input of the loudspeaker.
Make sure that the positive and nega-
tive connections do not touch, or this
may damage your power amplier.
2. Speaker Wire Channel
To ease installation, the speaker wiring
can be passed through these channels
to the binding posts.
3. Clamps
Once the loudspeaker is pressed into
an opening in the sheetrock, screws
on the front panel are turned to pull the
clamps out and down to press against
the sheetrock, and secure the loud-
speaker in place.
4. End Caps
These decorative end caps can be
painted to match your room decor. A
paint shield (12) is supplied to cover
the drivers during painting.
5. Ribbon Adjustment
This allows you to adjust the level of
the ribbon section relative to the other
drivers. The range of adjustment is
± 3 dB, and the default setting is in the
middle (0 dB). Perform a listening test
and adjust as desired.
6. Woofers
The CRW-2C and CRW-2 use two
identical custom drivers.
Features
CRW-2C
1 32