Filter
Top Products
20) PHONO/LINE SWITCH
Note: Key Lock and Digital output processing is only available when the LINE output is used.
21) DIGITAL OUT
Use this output to connect your T.80 to any SPDIF in equipped digital device.
22) POWER CORD CONNECTOR
Used to connect the included power cord.
23) POWER SWITCH
This switch turns the power on or off, including the motor and audio signal.
PART NAMES & FUNCTIONS
SPECIFICATIONS
APPLICATION:
This specification applies to the direct drive turntable unit T.80
STANDARD TEST CONDITION:
Ambient Temperature 20 +/- 2 degC
Relative Humidity 65% +/- 5%
NOTE: Measurements can be carried out between 5 degC to 35 degC and 45% to 85% relative humidity.
TURNTABLE SECTION:
Type 3-speed full manual
Motor 8pole, 3phase,brushless DC motor
Speeds 33
1
/3 and 45rpm and 78rpm
Wow and Flutter Less than 0.15% WRMS (JIS WTD) with 33
1
/3rpm
Pitch Controls +/- 8%, +/-12%
Starting Torque More than 1.6kgf.cm
Starting Time Less than 1 sec. with 33
1
/3 rpm
Braking Time Less than 1 sec. with 33
1
/3 rpm
Braking System Electronic brake
Time for Speed Change Less than 1 sec. from 33
1
/3 to 45 rpm.
Less than 1 sec. from 45 to 33
1
/3 rpm.
Less than 1 sec. from 33
1
/3 to 78 rpm
Audio Output Phono/Line output
TONEARM SECTION:
Type Static balanced straight shaped tone arm with cardan’s suspension
Effective Arm Length 191mm
Applicable Cartridge Weight 6~10g
AUDIO SECTION:
Digital Output 0.5Vp-p (LOAD 75 )
Preamp Frequency Response +1/-2dB 30Hz-20KHz/RIAA filter
Preamp Distortion Less than 0.03% at 1KHz
Preamp Noise Floor <-65dBv
CARTRIDGE SECTION:
Channel Separation More than 15dB
Channel Balance Within 2.5dB at 1KHz
Needle Pressure Range 1.5~2g