Filter
Top Products
19) COUNTERWEIGHT
Use this to balance the tone arm and to adjust the stylus pressure. See “tone arm and cartridge settings”
for proper adjustments.
20) 45-RPM ADAPTOR HOLDER
Place on the attached 45-rpm adaptor here. Push down the rear side of 45 rpm adaptor to take it.
21) EXTRA STYLUS HOLDER
Place extra headshells here.
22) PHONO/LINE OUTPUT L & R
This is the standard analog output (RCA jacks) which can be connected either to a phono or line input on
any DJ mixer, depending on the setting of the phono / line selector.
23) PHONO/LINE SWITCH
24) POWER CORD CONNECTOR
Used to connect the included power cord.
25) POWER SWITCH
This switch turns the power on or off, including the motor and audio signal.
APPLICATION:
This specification applies to the direct drive turntable unit T.120C
STANDARD TEST CONDITION:
Ambient Temperature 20 +/- 2 degC
Relative Humidity 65% +/- 5%
NOTE: Measurements can be carried out between 5 degC to 35 degC and 45% to 85% relative humidity.
TURNTABLE SECTION:
Type 3-speed full manual
Motor 16pole, 3phase,brushless DC motor
Speeds 33
1
/3 and 45rpm and 78rpm
Wow and Flutter Less than 0.1% WRMS (JIS WTD) with 33
1
/3rpm
Pitch Controls +/- 8%, +/-25%, +/-50%
Starting Torque More than 4.5kgf.cm
Starting Time 0.2~6 sec.(Adjustable)
Braking Time 0.2~6 sec.(Adjustable)
Braking System Electronic brake
Pitch Bend +/-6%
PART NAMES & FUNCTIONS
SPECIFICATIONS
22 23 24 25