Filter
Top Products
QUICK SETUP DIAGRAM
Study this setup diagram. Make sure all faders are at "zero" and all devices are off. First, connect all input sources and
processors. Next, connect your microphone and monitor headphones. Finally, connect the stereo outputs to the power
amplifier(s) and/or audio receivers such as tape decks. Plug your mixer into AC power. Now you are ready to switch everything
on. IMPORTANT: Always switch on your audio input sources such as turntables or CD players first, then your mixer, and
finally any amplifiers. When turning off, always reverse this operation by turning off amplifiers, then your mixer, and then input
devices.
TAPE DECK
POWER
AC IN~
115V
230V
AUDIO OUT
R L
DIGITAL
OUTPUT
FADER
START
ON OFF
TURNTABLE
CD PLAYER
POWER
AC IN~
115V230V
AUDIO OUT
R L
DIGITAL
OUTPUT
FADER
START
ON OFF
POWER AMPLIFIER
AC
ADAPTOR
TURNTABLE