Stanton A.900 Stereo Amplifier User Manual


 
IMPORTANT SAFETY INSTRUCTIONS
1. Read Instructions – All the safety and operating instructions should be read before
t
his product is operated.
2. Retain Instructions – The safety and operating instructions should be retained for
f
uture reference.
3
. Heed Warnings – All warnings on the appliance and in the operating instructions
should be adhered to.
4
. Follow Instructions – All operating and use instructions should be followed.
5
. Water and Moisture – The appliance should not be used near water - for exam-
p
le, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or
n
ear a swimming pool, and the like.
6. Wall or Ceiling Mounting – The product should be mounted to a wall or ceiling only
a
s recommended by the manufacturer.
7
. Heat – Appliance should be situated away from heat sources such as radiators,
heat registers, stoves, or other appliances (including amplifiers) that produce
h
eat.
8
. Power Sources – This product should be operated only from the type of power
source indicated on the rating label. If you are not sure of the type of power sup-
p
ly to your home, consult your product dealer or local power company. For prod-
ucts intended to operate from battery power, or other sources, refer the operat-
ing instructions.
9
. Grounding or Polarization – This product may be equipped with a polarized alter-
nation-current line plug (a plug having one blade wider than the other). This plug
w
ill fit into the power outlet only one way. This is a safety feature. If you are
u
nable to insert the plug fully into the outlet, try reversing the plug. If the plug
should still fail to fit, contact your electrician to replace your obsolete outlet. Do
n
ot defeat the safety purpose of the polarized plug.
1
0. Power-Cord Protection –Power-supply cords should be routed so that they are
not likely to be walked on or pinched by items placed upon or against them, pay-
ing particular attention to the cord in correspondence of plugs, convenience
receptacles, and the point where they exit from the appliance.
11. Cleaning - The appliance should be cleaned only as recommended by the man-
ufacturer. Clean by wiping with a cloth slightly damp with water. Avoid getting
water inside the appliance.
12. For AC line powered units - Before returning repaired unit to user, use an ohm-
meter to measure from both AC plug blades to all exposed metallic parts. The
resistance should be more than 100,000 ohms
13. Non-use Periods –The power cord of the appliance should be unplugged from
the outlet when left unused for a long period of time.
14. Object and Liquid Entry – Care should be taken so that objects do not fall and
liquids are not spilled into the enclosure through openings
15. Damage Requiring Service – The appliance should be serviced by qualified serv-
ice personnel when:
A. The power-supply cord or the plug has been damaged; or
B. Objects have fallen, or liquid has been spilled into the appliance; or
C. The appliance has been exposed to rain; or
D. The appliance does not appear to operate normally or exhibits a marked
change in performance; or
E. The appliance has been dropped, or the enclosure is damaged.
16. Servicing –Do not attempt any service to the appliance beyond that described in
t
he operating instructions. All other servicing should be referred to qualified serv-
ice personnel.
1
7. Ventilation – Slots and openings in the cabinet are provided for ventilation and
t
o ensure reliable operation of the product and to protect it from overheating, and
these openings must not be blocked or covered. The openings should never be
b
locked by placing the product on a bed, sofa, rug, or other similar surface. This
p
roduct should not be placed in a built-in installation such as a bookcase or rack
unless proper ventilation is the manufacturer’s instructions have been adhered
t
o.
18. Attachments – do not use attachments not recommended by the product manu-
f
acturer as they may cause hazards.
1
9. Accessories – Do not place this product on an unstable cart, stand, tripod, brack-
et, or table. The product may fall, causing serious injury to a child or adult, and
s
erious damage to the product. Use only with a cart, stand, tripod, bracket, or
t
able recommended by the manufacturer, or sold with the product. Any mounting
of the product should follow the manufacturer’s instructions, and should use a
m
ounting accessory recommended by the manufacturer.
20. Lightning – For added protection for this product during a lightning storm, or
when it is left unattended and unused for long periods of time, unplug it from the
w
all outlet and disconnect the antenna or cable system. This will prevent dam-
age to the product due to lightning and power-line surges.
2
1. Replacement Parts – When replacement parts are required, be sure the service
t
echnician has used replacement parts specified by the manufacturer or have
the same characteristics as the original part. Unauthorized substitutions may
r
esult in fire, electric shock, or other hazards.
22. Safety Check – Upon completion of any service or repairs to
this product, ask the service technician to perform safety
checks to determine that the product is in proper operating
condition.
23.This product is in compliance with EU WEEE regulations.
Disposal of end of life product should not be treated as
municipal waste. Please refer to your local regulations for
instructions on proper disposal of this product.
24. Carts and Stands – The appliance should be used only with
a cart or stand that is recommended by the manufacturer.An
appliance and cart combination should be moved with care.
Quick stops, excessive force, and uneven surfaces may
cause the appliance and cart combination to overturn.
25. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.”
CAUTION: To reduce the risk of electric shock, do not remove any
cover. No user-serviceable parts inside. Refer servicing to quali-
fied service personnel only.
The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the user
to the presence of un-insulated “dangerous voltage” within the product’s enclosure that may be of suf-
ficient magnitude to constitute a risk of electric shock.
The exclamation point within the equilateral triangle is intended to alert the user to the presence of
important operation and maintenance (servicing) instructions in the literature accompanying this appli-
ance.
CAUTION: To prevent electric shock, do not use this polarized plug with an extension cord, receptacle or other out-
let unless the blades can be fully inserted to prevent blade exposure.