Filter
Top Products
INTRODUCTION
Congratulations on purchasing SpeakerCraft’s AccuFit CRS7 Series of architectural loudspeakers. The AccuFit CRS7 Series
features a shallow 2
3
⁄4" sealed steel enclosure. Speakercraft offers the AccuFit Series to address space limitations, building
codes, sound transfer to adjoining walls and living environment concerns. The AccuFit CRS7 Series of shallow depth, fully
enclosed speakers ensure that the drivers have the proper amount of air space to deliver the best performance regardless
of the installation environment. This new line of technical advanced speakers was designed to fit just about any installation
application.
SPEAKER PLACEMENT
When following the below recommendations, please keep in mind that placement is always in the ceiling. AccuFit CRS7
speakers can be used as a pair for stereo listening, or for all five channels of a home theater system: front left and right,
center, and rear left and right.
SpeakerCraft recommends the use of a qualified custom installation specialist when installing your AccuFit CRS7 speakers. If
you need assistance in locating an installer, please contact SpeakerCraft at 1-800-448-0976.
1. Determine Your Primary Listening Area
The area where you will most likely be sitting when listening to your speakers is your primary listening area.
2.
Placement of Stereo Pair / Front Channels for Home Theater
Consider how far apart the speakers should be. To do this, think of your listening area as one tip of a triangle with each
leg of the triangle being equal. See speakers FL (front left) and FR (front right) in Figure 1. Place the speakers as close as
possible to the two points they represent on the triangle.
If the speakers are to be part of a home theater speaker system, they should be placed as close as possible to the area
above the screen. However, in some cases it may be better to place the speakers farther away from the screen in order
to maximize speaker separation. An example of a case when this would be desirable is when the television is positioned
directly in a corner (See Figure 2).
Figure 2
Figure 1
3. Placement of Center Channel for Home Theater
Place the center channel speaker in line between the front left and right speaker directly above the screen.
See C (center) in Figure 1.
4. Placement of Rear Channels for Home Theater
Rear channels should be placed behind the listening area. See RL (rear left) and RR (rear right) in Figure 1.
5. Checking for Obstructions
Before confirming the placement of the speakers, you should carefully consider the location of ceiling joists, electrical,
plumbing and other fixtures that may get in the way. If you are installing the speakers into an existing ceiling, you can
locate obstructions by noting the placement of fixtures and, if possible, gaining access to an attic or crawl space for fur-
ther analysis. A good stud-finder, found at any building supply store, will help you determine where the joists are located
in the ceiling.
1