Filter
Top Products
4
Flush Mounting:
1) Cut a 2 1/16” (52mm) diameter hole through the
mounting surface. If the surface is covered with
cloth or carpet, be careful not to tear or pull the
material. Sometimes it is a good idea to peel the
material away, and then trim it by hand.
2) Secure the cup in the mounting cutout by using
the spring clips and screw provided. Slip the
spring clips through the bottom of the cup and
tighten the screw until the cup is firmly seated.
See Figure 1.
3) Once the cup is secure, mount the tweeter into
the cup making sure to first pass the tweeter
wires through the openings in the cup. Turn the
outer swivel ring, (not the tweeter) clockwise to
lock it into place. See Figure 2. The tweeter
may be tilted approximately 15 degrees to
optimize dispersion and imaging.
INSTALLING
THE
TWEETER
The first step in a successful installation is thorough
planning. Choose the location for your speaker
components carefully. Follow these suggestions to
ensure proper imaging and the best performance:
• Select a location where each tweeter and
midrange/woofer can be mounted close to each
other. A good rule of thumb is a maximum of
one foot from cone to tweeter.
• Choose a location that offers the least
obstruction of sound to your ears.
• Try to mount the components on the same plane.
• Always check behind the chosen mounting
locations to make sure that there are no
obstructions (e.g., trunk springs, gas tank,
window tracks) or wires in the way, as well as to
make sure that there is ample support on which
to mount the components.
LOCATION
AND
MOUNTING
40.pub
page 4
Friday, September 10, 1999 21:04