Filter
Top Products
Controls
&
Functions
.
-
.-~
--
-
-
Controls
..
-
-
&
Functions
.
BASS
BOOST
I%i\
0
+I268
PWR(Power): This GREEN LED will illuminate when the amplifier
is
turned "ON". If it fails
BY
usina the bass boost function, bass notes at 50Hz are em~hasized as much as 12dB.
to illuminate, check the power connections to the Amplifier and fuses.
I
LlNE OUT LlNE IN
JJNE@..
LlNE OUT
CH~,.'"'
CHI
.--
CHI
I
power up the amplifier again.
These inputs are for signal cables from the source. Always use high quality shielded
RCA cables.
LlNE OUT LlNE IN
LINE IN UNEOUT
CH3
CHI
CHI.."-".
.
.a
PROT(h0tection): The amplifier protection circuitry
will
disable the amplifier if input overload.
shod circuit or extremely high temperature conditions are detected. When the protection
mode
is
in operation, the LED indicator on the side panel
will
be illuminated, indicating the
amplifier has gone into a self-preservation mode.
If you observe that the Protection LED is
lit,
please check the system carefully to determine
what has caused the protection clrcuit to engage. The amplifier can
be
reset by turning the
remote power off and then on again. If the amplifier shut down due to a thermal overload
condition, please allow
it
to cool down before restarting. If the amplifier shut down because
of an input overload or short circuit,
be
sure to repair these conditions before attempting to
The LlNE OUT allows you to build multiple amplifier systems without having to use splitter
cords to distribute the signal. Now it is simply a matter of bringing one set of RCAS into
the first amplifier, then using the line out RCA jacks as the feed to the
next amplifier.
Power
...
!*
+IL~:..
Rnmmtn
~nma
I
I
--
I
Due to the power requirements of the Amplifier, this connection should be made
directly to the positive(+) terminal of battery. For safety measure, install an in-line
fuse Holder (not included) as close to the battery positive(+) terminal as possible with
an ampere rating
;
not to exceed total value of fuses in Amp.
I
r
---,
.
m
Power
I
I
I
I
. .
.....
I