Filter
Top Products
TWEETER
SURFACE
MOUNTING
4
1) Remove the tweeter's plastic backplate
by separating the plate from the tweete
r
housing with your two thumbnails at one
of the terminal locations, gently prying
the two pieces until they snap apart.
See Figure 3.
2) Mark the location in which you are going
to mount the tweeter using the supplied
template and drill holes for each of the
two wires. Also drill small "pilaf' holes fo
r
the two mounting screws.
3) Mount the backplate with the two 1/2" flat
head screws. See Figure 4 below.
4) Feed the wires through the holes and
attach them to the speaker wires going
to the crossover. Position the tweeter
over the backplate and then simply snap
it back on. Be sure to feed the Red wire
through the (+) marked hole.
FIGURE 3
FIGURE 4
TWEETER
ANGLE
MOUNTING
1) Remove and discard the tweeter's plastic
backplate as described above.
2) Drill out the appropriate holes in the back
of the angle mount. Mark the location in
which you are going to mount the tweete
r
using the supplied template and drill holes
for each of the two wires. Also drill small
"pilot" holes for the two mounting screws.
3) Mount the angle mount backplate with the
two 1/2" flat head screws. See Figure 5.
4) Feed the wires through the holes and
attach them to the speaker wires going to
the crossover. Position the tweeter ove
r
the backplate and then simply snap it back
on.
FIGURE 5