Filter
Top Products
l
o.0
I
l
eoeo
d
0
0
0
““.a000
0000
i
123
/-
0
0
\
.
0
0
/
SOTlOM
VJEW
(PARUALJ
I
I
/
:
1.
2.
3.
4.
5.
6.
7.
0.
9.
Kev to Caiiouts
Fault LED
-
Indicates a blown fuse.
High Power LED
-
Indicates amplifier power on in “High Power’
mode.
High Current LED
-
Indicates amplifier power on in “High Current”
mode.
+12V
-
Connect to a fuse or circuit breaker, then to the batfery’s
positive post.
GND
-
Main ground connection.
Bolt
to a clean chassis ground in
the vehicle.
REM
-
Remote turn-on input from the head unit. Accepts
+lZV.
Speaker Output Connections
-
Left and right channels.
Input Level
-
independent Left and Right channel input level
controls.
Inputs
-
Right and left channel RCA (Differential Balanced
)
inputs;
only right channel input is used in “Mono” mode.
IO. Main Fuse-Main power supply fuse.
Heplace
only
with
the same
value fuse.
11. Crossover
S.1.P.s
-Crossover frequency settings for the amplifier.
See page 9 for more details.
12. Amplifier Crossover
-
Select high pass, low pass or full range
amplifier operation.
13. Mixed Mono/Stereo/Bridge
-
Select “Bridge” for bridged mono
operation (use right channel input). Select “Stereo” for coherent
stereo operation. Select “Mixed Mono’ for simultaneous stereo
I
bridged mono operation.
14. High Power
I
High Current Switch
-
Use HIGH CURRENT for
loads at or below
1
ohm stereo (2 ohms mono).
CAUTION: DO
NOT SWITCH WHEN AMPLIFIER IS TURNED ON.
4
5