Filter
Top Products
Electrical Wiring
Fuses
Mounting the Amplifier
All SOUND STORM S-SERIES amplifiers are equipped with easy top access screw terminals. These
terminals are 14K Gold Plated in order to ensure excellent electrical contact, and to resist
corrosion.
When making electrical connections to the amplifier, please observe the following:
Use at least 8 gauge or heavier wires for power and ground connections.
Wire the amplifier directly to the car battery.
For the ground connection, use the shortest possible wire to a good chassis ground point.
Wire the Remote connection to the auto start lead of your equalizer or power antenna.
Power fuses protect both the amplifier and the electrical system of your vehicle from fault
conditions. If you must replace the fuse in your SILVER amplifier, use a fuse of exactly the same
type and rating. A different type or rating of fuse may result in damage or fire.
Mark the location for the mounting screw holes by positioning the amplifier where you wish to
install it and use a scribe (or one of the mounting screws) inserted in each mounting hole to mark
the mounting surface. If the mounting surface is carpeted, measure the hole centers and mark
with a felt tip pen.
Drill pilot holes in the mounting surface for the mounting screws and insert the mounting screws
into these holes. Tighten them securely.
Note : Be sure to take note of any wires, lines or other devices in your vehicle which may be
located behind any mounting surface!
6