Filter
Top Products
12
GB
HDMI CTRL
(Control for HDMI)
To switch the Control for HDMI function on or off. (ON/OFF)
Refer to “Using the Control for HDMI function” (page 7) for details.
ON
P. THRU
(Pass through)
To set the power saving mode of the pass-through function for
HDMI signals. (AUTO/ON)
AUTO: Outputs signals from the HDMI OUT jack of the system in
standby mode according to the status of the TV. This setting
saves power in standby mode compared with the “ON”
setting.
ON: Always outputs signals from the HDMI OUT jack in standby
mode. If any TV other than “BRAVIA” is connected, use the
system with the “ON” setting.
Note: This item appears only when “CTRL (Control for HDMI)” is set
to “ON.”
AUTO
ARC
(Audio return channel)
To listen to digital sound from a TV compatible with the Audio
Return Channel (ARC) technology that is connected using a High
Speed HDMI cable. (ON/OFF)
Note: This item appears only when “CTRL (Control for HDMI)” is set
to “ON.”
ON
SET BT BT PWR
(BLUETOOTH power)
To switch the BLUETOOTH function of this system on and off. (ON/
OFF)
Note: If you change the setting to “OFF,” the BLUETOOTH function
and the NFC function become disabled.
ON
BT.STBY
(BLUETOOTH standby)
When the system has pairing information, the system is in the
BLUETOOTH standby mode even when it is turned off. (ON/OFF)
ON
AAC
(Advanced audio
coding)
To set whether or not the system will use AAC via BLUETOOTH.
(ON/OFF)
Note: If you change the setting when the system is connected with
a BLUETOOTH device, the system will be disconnected from
the device.
ON
SYSTEM A. STBY
(Auto standby)
To switch the AUTO POWER OFF function on or off. (ON/OFF) The
system turns off automatically when no operation has been made
within a certain period (about 20 minutes) and the system is not
receiving an input signal.
ON
VER
(Version)
To display the current firmware version.
–
SYS.RST
(System cold reset)
To reset menus and settings (sound fields, etc.) of the system to
the initial status when it does not work properly.
Refer to “Troubleshooting” (page 19) for details.
–
WS LINK To link the wireless sound system again (page 13). –
RF CHK To check whether the wireless sound system of the system can
communicate or not. (OK/NG)
–
Menu Function Default
AMP MENU
(return)/
(select)/
(proceed)/
(enter)