Filter
Top Products
21
GB
Additional Information
Remote control
The remote does not function.
• Point the remote at the remote sensor on
the amplifier.
• Remove any obstacles in the path between
the remote and the amplifier.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on
the remote.
Error messages
If there is a malfunction, the display shows a
code of two numbers. You can check the
condition of the system by the message. Refer
to the following table to solve the problem. If
any problem persists, consult your nearest
Sony dealer.
CHECK CODE 11
Irregular current is output from the
speakers. Turn off the amplifier, check the
central core of a speaker cord is not touching
the amplifier or other speakers, and turn on
again. When using a bi-amplifier
connection, check that the metal fittings
attached to the speakers that are used to
short the Hi/Lo terminals have been
removed from the speakers.
CHECK CODE 12
The amplifier section is overheated. Check
that the ventilation hole is not covered. Turn
off the amplifier, leave the amplifier for a
while, and turn on the power again. When
using a bi-amplifier connection, check that
the metal fittings attached to the speakers
that are used to short the Hi/Lo terminals
have been removed from the speakers.
CHECK CODE 13
The power section is overheated. Check that
the ventilation hole is not covered. Turn off
the amplifier, leave the amplifier for a while,
and turn on the power again. When using a
bi-amplifier connection, check that the
metal fittings attached to the speakers that
are used to short the Hi/Lo terminals have
been removed from the speakers.
CHECK CODE 14
Turn off the amplifier, check the central core
of a speaker cord is not touching the
amplifier or other speakers.
CHECK CODE 21
Turn off the amplifier and check that the
speaker cords are connected correctly, then
turn the power on again. When using a bi-
amplifier connection, check that the metal
fittings attached to the speakers that are used
to short the Hi/Lo terminals have been
removed from the speakers.