Filter
Top Products
Hooking Up and Setting Up the Speaker System
13
GB
STR-SL50/40 4-247-584-11(1) (GB, FR, DE, ES)
45°
90°
20°
B
CC
AA
When placing surround speakers behind you
(wide room)
Note
Do not place the center speaker further away from the
listening position than the front speakers.
Normal Speaker and Micro
Satellite Speaker
If you are using Select
Normal Speakers NORM. SP.
Micro Satellite Speakers MICRO SP.
The speaker size and the sub woofer selection
has been preset to “NORM. SP.”. You can
adjust the speaker size and sub woofer selection
when you select “NORM. SP.” (page 14).
To select “MICRO SP.”, turn off the power.
Then, hold down MUTING on the receiver and
press ?/1 on the receiver to turn on the power.
(To reset to “NORM. SP.”, do the same
procedure.)
When you select “MICRO SP.”, the speaker
size and sub woofer selection has been
configurated as follows:
Speaker Settings
FRONT SMALL
CENTER SMALL
SURROUND SMALL
SUB WOOFER YES
You cannot change the configuration if you select
“MICRO SP.”.
Tip
The setting for Micro Satellite Speaker (MICRO SP.)
has been programmed to optimize the sound balance.
If you use Sony’s Micro Satellite Speakers, select
“MICRO SP.”.
Caution
When you use Micro Satellite Speakers and the
speaker size is set to “LARGE”, you may not obtain
the correct soundstage. The speaker may also be
damaged at high volume position.
Specifying the speaker
parameters
1 Press MAIN MENU repeatedly to select
“ SET UP ”.
2 Press V or v to select the parameter
you want to adjust.
3 Press B or b to select the setting you
want.
The setting is entered automatically.
4 Repeat steps 2 to 3 until you have set
all of the parameters that follow.
Initial settings
Parameter Initial setting
SW
(SUB WOOFER) S.W. XXX YES*
L
R
(FRONT) XXXXX LARGE*
C
(CENTER) XXXXX LARGE*
SL
SR
(SURROUND) XXXXX LARGE*
L
R
DIST. X.X m 3.0 m
C
DIST. X.X m 3.0 m
SL
SR
DIST. X.X m 3.0 m
SL
SR
PL. XXXX LOW
* You can set this parameter only when you select
“NORM. SP.”.
continued
01GB04SPK_STRSL50.p65 4/24/03, 5:25 PM13