Filter
Top Products
Getting Started
3-856-134-51(1)
4
EN
/
/
Unpacking
Check that you have received the following supplied
item:
• Audio connecting cords (2)
Hooking Up the System
This section describes how to hook up the tape deck to
an amplifier. Be sure to turn off the power of each
component before making the connections.
Hookups
When connecting an audio connecting cord, be sure to
match the color-coded cord to the appropriate jacks on
the components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
Connect the tape deck to the amplifier as shown
below.
Tape deck Amplifier
To connect your tape deck to another tape deck
Connect both tape decks as shown below.
Tape deck
Another tape deck
ç :Signal flow
ç :Signal flow
Setting the voltage selector (only on
models supplied with a voltage selector)
Check that the voltage selector on the rear panel of the
tape deck is set to the local power line voltage. If not,
set the selector to the correct position using a
screwdriver before connecting the AC power cord to
an AC outlet.
to LINE OUT
Amplifier
to TAPE INto REC OUT
to an AC
(socket) outlet
to a
wall outlet
(mains)
REC OUT IN
Ç
ç
LINE
OUTIN
TAPE
L
R
L
R
L
R
ç
LINE
L
R
OUTIN
L
R
L
R
Ç
LINE
OUTIN
to LINE IN
VOLTAGE
220V
110V
240V
120V
Connecting the AC power cord
Connect the AC power cord to an AC outlet.
Where do I go next?
Now you’re ready to use your tape deck.
For basic operations, go to pages 5 to 7; for advanced
operations, go to the sections starting from page 8.
TC-KE300