Filter
Top Products
Getting Started
5
EN
Tape deck, DAT deck, or MD deck
Ç
ç
L
R
L
R
RECOUT
IN
TAPE1/DAT
LINE LINE
OUTPUT
INPUT
Use the configuration above to connect the OUTPUT and
INPUT jacks of:
—a tape deck or DAT deck to the TAPE1/DAT jacks.
—a tape deck or MD deck to the TAPE2/MD jacks.
Turntable
1 Remove the shorting plugs from the PHONO jacks before
connecting the cables (but not unless you connect a
turntable).
Do not attach the shorting plugs to any set of the RECOUT
jacks. Doing so may stop output from the amplifier or
cause the unit to malfunction.
2 Connect the audio connecting cords.
Ç
IN
PHONO
L
R
Note
To prevent hum, connect the earth lead to SIGNAL GND (y)
on the amplifier.
TV or video deck
Ç
IN
AUX
LINE
OUTPUT
L
R
L
R
EON CONTROL (TA-FE520R only)
Ç
IN
EON CONTROL
OUT
EON CONTROL
If your tuner is equipped with an EON CONTROL OUT
terminal, connect it to the EON CONTROL IN terminal on
the amplifier to allow use of the EON (Enhanced Other
Networks) function of the RDS (Radio Data System) (see
page 8).
Tape deckAmplifier
Amplifier
Turntable
Amplifier
TV or video deck
Amplifier
Tuner
Speaker System Hookups
Overview
Here you learn how to connect speakers to the
amplifier.
SPEAKERS
IN
REC OUT
IN
PHONO
IN
TUNER
IN IN
RECOUT
IN
CD
AUX TAPE2/MD
TAPE1/DAT
EON CONTROL
AC OUTLET
SPEAKERS
L
R
IMPEDANCE USE 4 - 16 Ω
SWITCHED 100W MAX
+
–
+
–
RL
S
I
G
N
A
L
G
N
D
y
IN
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
(+)
(–)
(+)
(–)
Twist the stripped ends of the cord about 15mm. Be sure to
match the speaker cord to the appropriate terminal on the
components: + to + and – to –. If the cords are reversed, the
sound will be distorted and will lack bass.
Hookups
]
}
]
}